configureFailPoint (internal)

发布于 2015-09-14 15:05:02 | 129 次阅读 | 评论: 0 | 来源: 网络整理

configureFailPoint¶

configureFailPoint is an internal testing command that configures failure points.

参数:	string – Specifies the name of the failure point. mode (string) – Controls behavior of failure point. Possible values are: `alwaysOn` and `off`. mode – Specify a document `{times: n}` to control the number of times that MongoDB will activate the failure point.

注解

configureFailPoint is an internal command that is not enabled by default. configureFailPoint must be enabled by using --setParameter enableTestCommands=1 on the mongod command line. configureFailPoint cannot be enabled during run-time.